Plumbers NZ is New Zealand's largest online plumbing, gas and drainage resource. Plumbing exam help, plumbing news, directory and free quotes.

Author Topic: Fellow Practitioner Issue 236 Dated 12 December 2014  (Read 235511 times)

0 Members and 2 Guests are viewing this topic.

Offline Badger

  • Hero Member
  • *****
  • Posts: 1989
  • Karma: +222/-151
Re: Fellow Practitioner Issue 236 Dated 12 December 2014
« Reply #480 on: March 02, 2016, 08:40:23 PM »
This is my profile write up, just awaiting "verification".....

I am trying to raise funds to fund lawyers to expose corruption and incompetence done at a risk to the NZ public, carried out by people entrusted with the NZ public health and safety, but are prepared to ignore huge conflicts of interest, persecuting the innocent to protect the guilty. One person almost killed in an explosion with other NZer's put at risk.

I have a problem with a governing Board, gifting a salesman a full certifying gas fitting license, then the same people allow this salesman to join an engineers group....

All the available proof points that he is so clueless that he installs and changes installs dangerously....so badly that it causes an explosion.....he faces a charge but it conveniently "disappears" before his hearing....

This same Board that gifted the license.....flippantly handing out these licenses to a select group......administers the gas safety certificate system so badly that it carries a disclaimer about accuracy.......still has to this day a case before it for the selling of 100's of blank, but signed certs being sold.....560 of them.....90% of these none compliant...with 16 potentially deadly......

These are the people who after I had proven 42 charges out of 44 charges were unfounded......they then went in my local area expressing their concerns about MY understanding of the regs and the fumes entering a building........they then go and ignore the exact same circumstances when an elderly couple actually make a complaint.......

And still to this day ignore a central heating job, installed by the same person gifted the licenses involved in the near fatal explosion..... where the stagnant water stored all summer in the central heating radiators....then comes out of the shower and other hot water outlets.......

There is much much more to this and the NZ public deserve to know, their homes and families could be affected.

I am going to donate any left over money from the donations, after the cost of the lawyers are met,  to the CHCH Ronald McDonald House, please take the time to read the huge amount of evidence I have posted on the link to the Plumbers forum.
You can't choose who you are.....but you are the sum of your choices.......

Offline Badger

  • Hero Member
  • *****
  • Posts: 1989
  • Karma: +222/-151
Re: Fellow Practitioner Issue 236 Dated 12 December 2014
« Reply #481 on: March 07, 2016, 05:25:26 PM »
Still waiting for verification......funny that!

Offline Badger

  • Hero Member
  • *****
  • Posts: 1989
  • Karma: +222/-151
Re: Fellow Practitioner Issue 236 Dated 12 December 2014
« Reply #482 on: March 17, 2016, 06:54:31 AM »
Still waiting....

Offline Badger

  • Hero Member
  • *****
  • Posts: 1989
  • Karma: +222/-151
Re: Fellow Practitioner Issue 236 Dated 12 December 2014
« Reply #483 on: March 17, 2016, 06:33:47 PM »
Just been watching the news tonight......about a guy who was "selling" dodgy driving licenses, a gentleman with the name Lovepreet Brar.....and the dismay expressed by the Government that there might be unqualified people masquerading behind these licenses issued by some people who work for the very organisation that is entrusted with this license issuing job......these licenses looking very authentic....so that public can't tell the difference.....

Apparently.....we need to look in to this asap, before someone gets hurt.....I mean issuing licenses to people who are incompetent, untrained and ..... well dicks really.....because they know someone who works there......risking peoples lives for selfish reasons......hmmmm where I have heard a similar situation like this before..........

Oh wait there now I remember....

Can anyone tell me the difference between the Board issuing a license to John Darnley?

Remember all the available evidence (and there is a lot) points to him being responsible for blowing at least one person up and then lets not forget the unresolved ticking time bomb of the legionnaires risk....not to mention all the other jobs.....

I wonder how much he paid for the license? 20 years of signing off gas work would be quite lucrative.....





Spot the difference, one is a guy with a very cool name and is a private entity.......the other is a government backed board.......

Offline Badger

  • Hero Member
  • *****
  • Posts: 1989
  • Karma: +222/-151
Re: Fellow Practitioner Issue 236 Dated 12 December 2014
« Reply #484 on: March 19, 2016, 08:13:21 AM »
And know they are worried that this Lovepreet Brar was issuing heavy goods licenses people who have no idea how to drive large heavy vehicles....

Bit like granting a salesman who never sat an apprenticeship with a full gas certifying license after one oral exam and then allowing him to join an engineers industry group....but what if then this guy nearly killed someone in a gas explosion.....what dismay was expressed then........not a lot, they just frame someone else for it......there's a nice system we live in eh? nice and democratic....







.

Offline Badger

  • Hero Member
  • *****
  • Posts: 1989
  • Karma: +222/-151
Re: Fellow Practitioner Issue 236 Dated 12 December 2014
« Reply #485 on: March 22, 2016, 07:04:24 AM »
Well the news is full of them this week.....a camera man leaves a tape recorder next to 2 politicians in a café having a cup of tea.....the camera man gets accused of doing this purposely......he thinks he is due 1.25 million dollars and the PM is willing to settle out of court....


I wish I was a camera man, not a gasfitter....I can prove not only was I set up and framed and lied about, but that the guilty walked free after nearly killing some one in an explosion.....oh to be a camera man, they are so integral to the running of NZ....so  much more than plumbers and gasfitters.

Why are we shat on when every they like?

 

Offline Badger

  • Hero Member
  • *****
  • Posts: 1989
  • Karma: +222/-151
Re: Fellow Practitioner Issue 236 Dated 12 December 2014
« Reply #486 on: April 09, 2016, 08:54:42 AM »
Severn Years ago today, the 9th of April, a man nearly died in an explosion.....evidence was withheld by the Board investigator and misrepresented and ignored....with 220k spent investigating me with only a further 30K approx. spent on the guy who all the evidence pointed to.

Charges disappearing before trial for the person who all the evidence pointed to.

Still waiting for my "give a little" page to be authenticated......


If you think you play on a fair level playing field with a neutral ref.....you're delusional.

Offline Badger

  • Hero Member
  • *****
  • Posts: 1989
  • Karma: +222/-151
Re: Fellow Practitioner Issue 236 Dated 12 December 2014
« Reply #487 on: April 12, 2016, 06:39:39 PM »
Hi Guys please see the reply below, apparently the page for the "givealittle" donations is live, please could you test it and see if it works as it should.

I am hoping you will take this opportunity to force an issue that will give you all protection in the long run, to send a message to the powers that be, that cronyism and corruption isn't ok, that we all deserve to get a fair go and to be judged on a level and even playing field, looked over by an impartial system, with a search for truth and that the safety of the Kiwi public comes before who's mate you are.

Remember that any monies left over from covering the legal fees to force this issue, goes to CHCH Ronald McDonald House, a place I have used where real problems are dealt with, not some bullshit ones invented by a plumbers Board trying to justify their existence.

Please give what you can, every little helps.

Thank you in advance for your donations.






Hi Paul Gee,

This is an automated notification that Givealittle page: http://givealittle.co.nz/cause/justiceandfulldisclosure4nz has been moderated by the Givealittle service team.

Please note that your Givealittle page is active and you are able to share the above page link with your own networks in order to receive the minimum 3 donations required to complete the moderation process. Time to get sharing this page with generous folk!



http://givealittle.co.nz/cause/justiceandfulldisclosure4nz

Offline Badger

  • Hero Member
  • *****
  • Posts: 1989
  • Karma: +222/-151
Re: Fellow Practitioner Issue 236 Dated 12 December 2014
« Reply #488 on: April 12, 2016, 06:53:36 PM »
http://givealittle.co.nz/cause/justiceandfulldisclosure4nz

If you Google this link, then it does go to the page, but it needs three donations to allow the link to be functional.


Offline Wal

  • Moderator
  • Hero Member
  • *****
  • Posts: 572
  • Karma: +83/-0
Re: Fellow Practitioner Issue 236 Dated 12 December 2014
« Reply #489 on: April 13, 2016, 06:24:32 AM »
Well done Badger. I've made a small donation to help get it started and will make more later as we progress. It's a pity that yet again tradespeople have to pay to get fairness and accountability. When to we stop paying to protect the public?

Offline Badger

  • Hero Member
  • *****
  • Posts: 1989
  • Karma: +222/-151
Re: Fellow Practitioner Issue 236 Dated 12 December 2014
« Reply #490 on: April 13, 2016, 07:09:07 AM »
Thank you very much Wal,

I really believe that if this is exposed for what it is, it will set a president for what the powers that be can do to us.....

....it is just plain wrong to protect a small cabal of people at a very real risk to the NZ public and at a cost of the innocent......

What sort of system do we want to work under?

I think it should be fair, transparent and above all else based on fact with a goal to protect the public and the integrity of the trade.....it is all very well to say this PGDB in your newsletter.....but lets see some action.

The Federation have been showing you the proper and true way for a long time now....lets see some real action, not just talk.

Offline robbo

  • Hero Member
  • *****
  • Posts: 1259
  • Karma: +83/-7
Re: Fellow Practitioner Issue 236 Dated 12 December 2014
« Reply #491 on: April 13, 2016, 04:26:08 PM »
hi badger, any reason I get  `404 not found` cheers

Offline Badger

  • Hero Member
  • *****
  • Posts: 1989
  • Karma: +222/-151
Re: Fellow Practitioner Issue 236 Dated 12 December 2014
« Reply #492 on: April 13, 2016, 05:10:59 PM »
Hi Robbo,

Until I get the first initial three donations my "give a little" page won't be "live".....if you copy and paste the link into Google, then it comes up and it directs you to the donation page, then when the three initial donations are in then it should be accessible via this forum. I think, but I am a plumber, lol.

Thanks for your support.

Offline robbo

  • Hero Member
  • *****
  • Posts: 1259
  • Karma: +83/-7
Re: Fellow Practitioner Issue 236 Dated 12 December 2014
« Reply #493 on: April 13, 2016, 08:22:34 PM »
HI BADGER, o.k. I can get to the givealittle site but what then lots of site choices I go no further, perhaps Wal can direct me,cheers

Offline Badger

  • Hero Member
  • *****
  • Posts: 1989
  • Karma: +222/-151
Re: Fellow Practitioner Issue 236 Dated 12 December 2014
« Reply #494 on: April 13, 2016, 08:48:57 PM »
My Missis can't find it either, perhaps Wal could show us....or its been taken down....that would be weird eh?


Share via digg Share via facebook Share via linkedin Share via twitter

Similar Topics

  Subject / Started by Replies / Views Last post
clip
Fellow Practitioner Issue 235 Dated 5 December 2014

Started by Wal

5 Replies
2979 Views
Last post December 10, 2014, 09:43:07 AM
by Jaxcat
clip
Fellow Practitioner Issue 184 Dated 6 December 2013

Started by Wal

2 Replies
2515 Views
Last post December 06, 2013, 02:13:52 PM
by Jaxcat
clip
Fellow Practitioner Issue 185 Dated 13 December 2013

Started by Wal

5 Replies
3094 Views
Last post December 13, 2013, 04:01:14 PM
by robbo
clip
Fellow Practitioner Issue 186 Dated 20 December 2013

Started by Wal

1 Replies
1762 Views
Last post December 23, 2013, 06:39:28 AM
by Watchdog
 
Share this topic...
In a forum
(BBCode)
In a site/blog
(HTML)