Plumbers NZ is New Zealand's largest online plumbing, gas and drainage resource. Plumbing exam help, plumbing news, directory and free quotes.

Author Topic: Wetback to triple inlet  (Read 2517 times)

0 Members and 1 Guest are viewing this topic.

Offline Tyler

  • Newbie
  • *
  • Posts: 1
  • Karma: +0/-0
  • Im new @ Plumbers NZ!
Wetback to triple inlet
« on: February 21, 2015, 10:58:13 PM »
Hi we recently moved to a lifestyle block and are going to rare calves. The shed we are going to use has no power but has a wetback fire installed we have a triple inlet cylinder low pressure cylinder. My question is can we plumb the wetback to the two side inlets, the cylinder will be on a stand the feed from the cylinder will have to drop about a foot to connect to the wetback inlet and the wetback outlet will be slightly higher about an inch then the cylinder inlet. Will this allow it to thermosyphon even though the inlet And outlet on the cylinder are at the same level

Linkback: https://www.plumbers.nz/q-and-a-wetbacks/61/wetback-to-triple-inlet/1836/

Offline Enn

  • Full Member
  • ***
  • Posts: 192
  • Karma: +22/-1
  • Ex-chef
Re: Wetback to triple inlet
« Reply #1 on: February 22, 2015, 11:38:58 AM »
Wet back cylinders have 2 configurations side and bottom entry, 25mm connections. the water in and draw off /vent are usually 20mm. the cylinder should be min 600mm above the wetback with the circulators rising to the connections.
and yes this is a Certifying plumbers job.
Have a look on this forum at the possible repercussions for doing restricted work of this nature.
''Never have so many been fooled by so few''
Plumbing is not a career it is a disease....

Offline Enn

  • Full Member
  • ***
  • Posts: 192
  • Karma: +22/-1
  • Ex-chef
Re: Wetback to triple inlet
« Reply #2 on: February 22, 2015, 09:32:25 PM »
cylinder 300mm min above wet back......


Share via digg Share via facebook Share via linkedin Share via twitter

Similar Topics

  Subject / Started by Replies / Views Last post
xx
Diameter of inlet pipe into LP HWC

Started by Davr0s

1 Replies
3800 Views
Last post August 31, 2011, 01:45:10 PM
by Plumber
thumbup
Wetback installation guidelines / how to install a wetback

Started by Plumber

4 Replies
21494 Views
Last post June 19, 2012, 10:23:21 PM
by integrated
xx
Wetback not circulating

Started by Wetbackwiz

2 Replies
3953 Views
Last post August 02, 2012, 11:22:33 PM
by 07442
xx
Wetback Problem

Started by Murray Glue

13 Replies
23163 Views
Last post June 07, 2013, 09:42:46 AM
by Plumber
 
Share this topic...
In a forum
(BBCode)
In a site/blog
(HTML)